Worked examples, not quotations
Borewell drilling price by depth in Hyderabad
The figures below are built directly from the per-foot rates above. They assume a standard 6.5-inch bore, a typical Hyderabad mix of soil, weathered rock and increasing granite with depth, roughly 40â70 ft of casing depending on depth, plus rig mobilisation and flushing. They do not include pump, motor, cable, panel or plumbing. Treat every figure as a budgeting starting point, not a price for your plot.
Estimated borewell drilling price by depth â 6.5" bore, drilling + casing + mobilisation + flushing (pump excluded)
| Borewell Depth | Estimated Price Range | What usually drives the top of the range |
|---|
| 200 ft | âš40,000 â âš55,000 | Granite close to the surface, or extra casing in loose ground |
|---|
| 300 ft | âš50,000 â âš73,000 | A long granite section rather than weathered rock |
|---|
| 400 ft | âš59,000 â âš88,000 | Mostly granite below the first 100 ft |
|---|
| 500 ft | âš71,000 â âš1,05,000 | Continuous hard rock plus longer casing |
|---|
| 700 ft | âš90,000 â âš1,37,000 | Deep granite drilling and a longer job on site |
|---|
| 1000 ft | âš1,21,000 â âš1,82,000 | Granite almost throughout, plus access and casing needs |
|---|
â swipe sideways â
Estimated ranges, subject to site conditions. Pump, motor, cable, panel and plumbing are quoted separately.
Borewell drilling price for 300 feet in Hyderabad
For a 6.5-inch bore taken to 300 ft, the drilling charge alone typically lands between roughly âš28,000 and âš45,000, depending on how much of that depth is soil and weathered rock rather than granite. Add around 40â50 ft of casing, the mobilisation charge and flushing, and the realistic range for drilling, casing, mobilisation and flushing is about âš50,000 â âš73,000. A 300 ft bore is a common depth for independent houses in parts of Hyderabad, but depth is never chosen in advance â it is confirmed while drilling.
Borewell drilling price for 500 feet in Hyderabad
At 500 ft the drilling charge for the same diameter typically runs between roughly âš47,000 and âš75,000, because a larger share of that depth is usually hard rock. With 50â60 ft of casing, mobilisation and flushing added, the working range is about âš71,000 â âš1,05,000. A 500 ft bore also usually needs a higher-HP pump and more submersible cable, so the pump quotation rises alongside the drilling price.
Borewell drilling price for 1000 feet in Hyderabad
A 1000 ft bore is a serious job rather than a routine one, and is normally considered only where shallower bores in the area have not held water. Drilling at this depth typically falls between roughly âš95,000 and âš1,50,000, and with casing, mobilisation and flushing the range works out to about âš1,21,000 â âš1,82,000. Before committing to a bore this deep, it is worth asking whether cleaning or reboring an existing bore on the property could solve the problem for far less.
đ Why the price does not scale in a straight line
A 700 ft borewell does not cost exactly 3.5 times a 200 ft borewell. Mobilisation and a share of the casing and setup cost are largely fixed regardless of depth, so the effective cost of each extra foot is not identical down the whole bore.
đĒ¨ Deeper usually means harder rock
Across much of Hyderabad, the deeper sections are more likely to run through continuous granite than the upper layers of soil and weathered rock. That is a major reason the average rate per foot rises as a bore goes deeper, independently of the extra footage.
đ Pump cost rises with depth too
A deeper bore generally needs a higher-HP submersible pump and more cable, and sometimes a wider casing to accommodate it. All of that sits outside the drilling and casing figures shown in this table.
đ Illustrative, not guaranteed
Your site could sit above or below these ranges depending on the exact granite proportion, casing length and access. The only way to get a figure specific to your plot is a site visit followed by a written quotation.
Hyderabad Borewell Drillers
Borewell Contractors ¡ Hyderabad